| Periodic Electrical Inspection & Report - to BS 7671 |
The IEE Wiring Regulations (BS 7671) require that Periodic Inspection and Testing of electrical installations is carried out at such intervals as are consistent with the type of installation, its use and operation, the frequency of maintenance, and the external influences upon it.
Examples of maximum recommended initial periods between inspections are as follows:
| Office Buildings | Every 5 years |
| Retail Premises | Every 3 years |
| Swimming Baths | Every year |
| Domestic Dwellings | At change of occupancy, or every 10 years |
It is recommended by the Institute of Electrical Engineers, that buildings over five years old are subjected to a periodic inspection, and as a minimum should continue to be inspected and tested every five years; a report of inspection should be issued, together with test results and any recommendations.
Extent of
the Work
When
entering into an agreement for electrical inspection and testing of
a building under your control it is a fundamental requirement that
the extent and limitations of the inspection and testing are fully
described. It is recommended that the following be agreed prior to
beginning the work, and we can assist you in determining your exact
requirements for inspection and testing.
As it is
neither practical nor possible to inspect all parts of an
installation, we will agree a sampling process. This is normally in
the order of 10%-20% of all accessories, fittings and control
equipment.
For much of the testing the electrical system will be switched off.
If this is a problem we can arrange the work at times when this is
more convenient.
Reports
On completion of the Inspection and Test a report will be provided,
detailing the condition of the installation, results of all tests
carried out, a list of any faults, and recommendations and a
conclusion as to relative safety of the installation.
Frequency
In conjunction with requirements from the Institute of Electrical
Engineers (IEE) and Local Authorities,
PAT Testing Aberdeen recommend the following inspection and testing
timescale for let properties:
| Inspection |
Flats and Houses |
HMOs and Bed sits |
| Periodic Inspection |
Every 5 Years |
Every 3 Years |
Gas Safety Inspection Test Details:
GAS - Testing of up to Three Appliances.
Boiler:Boiler Position checked and reported on
Gas Hob:
GAS FIRES (One Only):
Standard - Gas Fire:
WE ISSUE A REGP45 CERTIFICATE
Together with a detailed report on any
defects and a detailed estimate for us to carry out the works.
We also remind you one month before a certificate must be renewed.
